Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. External elements of a body
8.3. System of passive safety
8.3.1. General information
8.3.2. Precautionary measures
8.3.3. Electric system
8.3.4. The module of a safety cushion and the device for a naduvaniye of an airbag (gas generator)
8.3.5. Plait of wires of SRS
8.3.6. Activation of a control lamp of SRS
8.3.7. Hour spring
8.3.8. System of definition of presence of the passenger on a forward seat (PPD)
8.3.9. Sensor of lateral blow
8.3.10. Removal and check of the module of a face-to-face safety cushion of the driver (DAB)
8.3.11. Removal of the module of a safety cushion of the passenger (PAB)
8.3.12. Prednatyazhitel of seat belts (gas generator)
8.3.13. Removal of a prednatyazhitel
8.4. Heater and conditioner
8.5. Tables
9. Electric equipment schemes
 









8-3-11-snyatie-modulya-podushki-bezopasnosti-passazhira-rab.html

8.3.11. Removal of the module of a safety cushion of the passenger (PAB)

Removal

NOTE
Do not assort and do not repair the safety cushion module.
Do not drop the block, do not allow module pollution by water, oil or greasing. Replace the module in the presence of dents, cracks, deformations or a rust.
The module of a pillow should be stored on a flat surface by a slip up. Do not put any subjects on an overlay of a pillow.
Do not allow heating of the module of a pillow over 93 °C.
Blasting and utilization of a pillow should be carried out according to special procedure.
Never try to measure resistance of an electrofuse of a pillow, even by means of a special tester: sudden blasting a pillow which will lead to accident is possible.
If the pillow worked, the module of a pillow should be replaced with the new.


Disconnect a wire from the negative plug of the storage battery.

ATTENTION
Before the beginning of works make a pause not less than 30 pages.

Remove a ware box.
Disconnect the socket of the module of a safety cushion of the passenger.
Remove the forward panel and remove the module of a safety cushion of the passenger.
The upholstery of the module of a safety cushion of the passenger is incorporated with an upholstery of the forward panel. Therefore when blasting a pillow the forward panel should be replaced.

«previous page
8.3.10. Removal and check of the module of a face-to-face safety cushion of the driver (DAB)
following page»
8.3.12. Prednatyazhitel of seat belts (gas generator)