Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
6.1. General information
6.1.1. Check and adjustment of a pedal of a brake
6.1.2. Check of operation of the vacuum amplifier of brakes without a tester
6.1.3. Air removal from a hydraulic actuator of brakes
6.1.4. Check and adjustment of a course of the lever of the parking brake
6.1.5. Removal and installation of the vacuum amplifier of brakes
6.1.6. Check of highways of brake system
6.1.7. Removal and installation of a pedal of a brake
6.1.8. Removal, check and installation of forward brake shoes
6.1.9. Dismantling, check and assembly of a brake support
6.1.10. Dismantling, check, assembly and installation of the main brake cylinder
6.1.11. Regulator of pressure of back brakes
6.1.12. Removal, check and installation of back drum-type brakes
6.1.13. Replacement of the working brake cylinder
6.1.14. Removal, check and installation of the parking brake
6.1.15. Anti-blocking system of brakes (ABS)
6.1.16. Removal and installation of the electronic ABS control unit
6.1.17. Removal and check of sensors of frequency of rotation of a wheel (ABS)
6.2. Tables
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 







6-1-7-snyatie-i-ustanovka-pedali-tormoza.html

6.1.7. Removal and installation of a pedal of a brake

Brake pedal
Fig. 6.15. Brake pedal



Removal
Remove the switch of stoplights.
Remove шплинт and take out a finger of an earring of draft.

Nuts of fastening of an arm of a pedal of a brake
Fig. 6.16. Nuts of fastening of an arm of a pedal of a brake


Unscrew nuts of fastening of an arm of a pedal of a brake (fig. 6.16).
Remove an arm together with a brake pedal.

Check
Estimate degree of wear of plugs of a pedal.
Be convinced of absence of deformation of a pedal.
Check a returnable spring.
Check the switch of stoplights.

Resistance measurement between switch conclusions
Fig. 6.17. Resistance measurement between switch conclusions


By means of an ohmmeter measure resistance between switch conclusions (fig. 6.17).
If at the pressed pusher of the switch the chain is opened (infinitely big resistance), and at the released pusher is (zero resistance) - the switch in norm.

Installation
Installation is made upside-down.

NOTE
Do not forget to fix an earring finger the shplinty.

Tighten nuts of fastening of an arm of a pedal the regulated moment of 13-16 N · m.
Adjust height of installation of a pedal and its free wheeling.
Establish the switch of stoplights.

«previous page
6.1.6. Check of highways of brake system
following page»
6.1.8. Removal, check and installation of forward brake shoes