Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. Power supply system
7.2. Charging system
7.3. Sitema of start
7.3.1. General information
7.3.2. Removal and starter installation
7.3.3. Adjustment of an axial gap of a leading gear wheel
7.3.4. Check of an involving winding of the traction relay
7.3.5. Check of a holding winding of the traction relay
7.3.6. Check of return of an anchor of the traction relay
7.3.7. Test in an idling mode
7.3.8. Dismantling, check of components and starter assembly
7.4. Anticreeping system
7.5. Tables
8. Body
9. Electric equipment schemes
 







7-3-6-proverka-vozvrata-yakorya-tyagovogo-rele.html

7.3.6. Check of return of an anchor of the traction relay

Disconnect a wire of a winding of a stator from a conclusion of "M" of the traction relay.

Scheme of check of return of an anchor of the traction relay
Fig. 7.60. Scheme of check of return of an anchor of the traction relay


Connect wires from plugs 12 In storage batteries to a conclusion of "M" and the starter case (fig. 7.60).

ATTENTION
It is necessary to make this check quickly, no more than 10 with, for prevention of a peregoraniye of a winding of a starter.

Put forward a hand a leading gear wheel and release. If the leading gear wheel comes back at once to a starting position, the traction relay regularly means. If is not present, replace the traction relay.

«previous page
7.3.5. Check of a holding winding of the traction relay
following page»
7.3.7. Test in an idling mode