Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. Power supply system
7.2. Charging system
7.3. Sitema of start
7.3.1. General information
7.3.2. Removal and starter installation
7.3.3. Adjustment of an axial gap of a leading gear wheel
7.3.4. Check of an involving winding of the traction relay
7.3.5. Check of a holding winding of the traction relay
7.3.6. Check of return of an anchor of the traction relay
7.3.7. Test in an idling mode
7.3.8. Dismantling, check of components and starter assembly
7.4. Anticreeping system
7.5. Tables
8. Body
9. Electric equipment schemes
 









7-3-3-regulirovka-osevogo-zazora-vedushhejj-shesterni.html

7.3.3. Adjustment of an axial gap of a leading gear wheel

Disconnect a wire of a winding of a stator from a conclusion of "M" of the traction relay.

Fig. 7.56. Scheme of adjustment of an axial gap of a leading gear wheel


Connect wires from plugs 12 In storage batteries (via the switch) to «S» conclusions (+) and «M» (–) the traction relay (fig. 7.56).
Establish the switch in situation "Incl.", thus the leading gear wheel of a starter will be pushed forward against the stop.

ATTENTION
It is necessary to make this check quickly, no more than 10 with, for prevention of a peregoraniye of a winding of a starter.


Fig. 7.57. Check of an axial gap of a leading gear wheel


With the help щупа measure an axial gap between a leading gear wheel and a restrictive ring. If the axial gap does not correspond to a range of nominal rates, adjust it by installation or removal of adjusting laying between the traction relay and a forward arm of a starter (fig. 7.57).
Nominal gap: 0,5–2,0 mm.

«previous page
7.3.2. Removal and starter installation
following page»
7.3.4. Check of an involving winding of the traction relay