Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
7.1. Power supply system
7.2. Charging system
7.3. Sitema of start
7.3.1. General information
7.3.2. Removal and starter installation
7.3.3. Adjustment of an axial gap of a leading gear wheel
7.3.4. Check of an involving winding of the traction relay
7.3.5. Check of a holding winding of the traction relay
7.3.6. Check of return of an anchor of the traction relay
7.3.7. Test in an idling mode
7.3.8. Dismantling, check of components and starter assembly
7.4. Anticreeping system
7.5. Tables
8. Body
9. Electric equipment schemes
 









7-3-5-proverka-uderzhivayushhejj-obmotki-tyagovogo-rele.html

7.3.5. Check of a holding winding of the traction relay

Disconnect a wire of a winding of a stator from a conclusion of "M" of the traction relay.

Fig. 7.59. The scheme of check of a holding winding of the traction relay


Connect wires from plugs 12 In storage batteries to «S» conclusion (+) and to the starter case (fig. 7.59).

ATTENTION
It is necessary to make this check quickly, no more than 10 with, for prevention of a peregoraniye of a winding of a starter.

If the leading gear wheel which has been put forward manually against the stop, remains in the put-forward situation, the holding winding means is serviceable. If the gear wheel is involved, means there is a break in a holding winding. In this case replace the traction relay.

«previous page
7.3.4. Check of an involving winding of the traction relay
following page»
7.3.6. Check of return of an anchor of the traction relay