Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. External elements of a body
8.3. System of passive safety
8.4. Heater and conditioner
8.4.1. General information
8.4.2. Installation of connecting details
8.4.3. Depression creation in system
8.4.4. Removal and installation of a nave of the coupling and compressor pulley
8.4.5. Removal and installation of a winding of the electromagnetic coupling of the compressor
8.4.6. Removal and installation of an epiploon of a shaft of the compressor
8.5. Tables
9. Electric equipment schemes
 







8-4-5-snyatie-i-ustanovka-obmotki-ehlektromagnitnojj-mufty-kompressora.html

8.4.5. Removal and installation of a winding of the electromagnetic coupling of the compressor

Removal
Remove a nave of the coupling and a pulley.
Establish in compressor boring the adaptation for protection of a shaft.
Establish a pulley on a compressor shaft. Establish an end face of a bolt of a stripper in a concave central part of the adaptation for protection of a shaft, get stripper captures under a winding holder.

Spressovka of a winding
Fig. 8.75. Spressovka of a winding


Rotation of a bolt of a stripper press a winding (fig. 8.75).

Installation
Clear a landing surface of a holder of a winding.
Establish the compressor in vertical situation and establish a winding on a forward head of the compressor.
Check correctness of position of the socket of a winding of the coupling.
Establish the adaptation for compression on a sock of the compressor and in the winding center.
Establish two 8-inch captures on the compressor and the adaptation for compression. Pads of captures should be deeply got for a forward landing part of the compressor, and the bolt should settle down in the adaptation center for an obzhatiya.

Bolt for a winding napressovka
Fig. 8.76. A bolt for a winding napressovka


Rotating a bolt a key, it is reliable напрессуйте a winding on a forward head of the compressor (fig. 8.76).
Establish a pulley and a coupling nave on the compressor.

«previous page
8.4.4. Removal and installation of a nave of the coupling and compressor pulley
following page»
8.4.6. Removal and installation of an epiploon of a shaft of the compressor