Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
8.1. General information
8.2. External elements of a body
8.3. System of passive safety
8.4. Heater and conditioner
8.4.1. General information
8.4.2. Installation of connecting details
8.4.3. Depression creation in system
8.4.4. Removal and installation of a nave of the coupling and compressor pulley
8.4.5. Removal and installation of a winding of the electromagnetic coupling of the compressor
8.4.6. Removal and installation of an epiploon of a shaft of the compressor
8.5. Tables
9. Electric equipment schemes
 







8-4-4-snyatie-i-ustanovka-stupicy-mufty-i-shkiva-kompressora.html

8.4.4. Removal and installation of a nave of the coupling and compressor pulley

Removal

Otvorachivaniye of a bolt of fastening of a nave
Fig. 8.67. Otvorachivaniye of a bolt of fastening of a nave


Key unscrew a bolt of fastening of a nave (fig. 8.67).

Removal of a nave and adjusting laying from a compressor shaft
Fig. 8.68. Removal of a nave and adjusting laying from a compressor shaft


Remove a nave and adjusting laying from a compressor shaft. At the complicated removal wrap a bolt of 8 mm in an opening of an end face of a shaft and remove a nave from a shaft (fig. 8.68).

Removal of a lock ring of a pulley
Fig. 8.69. Removal of a lock ring of a pulley


Remove a lock ring of a pulley (fig. 8.69).

Removal of a pulley from the compressor
Fig. 8.70. Removal of a pulley from the compressor


Remove from the compressor a pulley assembled with the bearing (fig. 8.70).

Installation
Clear landing surfaces of a pulley and the bearing in a compressor head, having removed dirt and a rust.

Pulley and bearing installation on the compressor
Fig. 8.71. Pulley and bearing installation on the compressor


Establish a pulley and the bearing on the compressor (fig. 8.71).

Installation of a lock ring
Fig. 8.72. Installation of a lock ring


Establish a lock ring a facet outside (fig. 8.72).

Installation of adjusting laying
Fig. 8.73. Installation of adjusting laying


Establish adjusting laying of the demanded thickness by shlitsevy grooves inside, establish a nave for the end of a shaft of the compressor (fig. 8.73).
Wrap a new bolt of fastening of a nave in an end face of a shaft of the compressor and tighten it the demanded moment
Inhaling moment: 11–14 N · m.

ATTENTION
Do not apply the pneumatic tool.


Gap check between a nave of the coupling and a pulley surface
Fig. 8.74. Gap check between a nave of the coupling and a pulley surface


Check shchupy a gap between a nave of the coupling and a pulley surface (fig. 8.74).
Adjusting gap of the coupling: 0,05–0,08 mm.
Gap check in 3 points of a circle of a pulley.
If the adjusting gap of a nave does not keep within the specified limits, adjust it, having put adjusting laying of the corresponding thickness.

«previous page
8.4.3. Depression creation in system
following page»
8.4.5. Removal and installation of a winding of the electromagnetic coupling of the compressor