Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
4. Running gear
4.1. General information
4.2. Forward suspension bracket
4.2.1. Removal and installation of a forward amortizatorny rack
4.2.2. Dismantling, check and assembly of an amortizatorny rack
4.2.3. Removal, check and installation of the bottom lever of a suspension bracket
4.2.4. Removal, check and installation of the forward stabilizer of cross-section stability
4.3. Back suspension bracket
4.4. Tables
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 







4-2-4-snyatie-proverka-i-ustanovka-perednego-stabilizatora-poperechnojj-ustojjchivosti.html

4.2.4. Removal, check and installation of the forward stabilizer of cross-section stability

Forward stabilizer of cross-section stability
Fig. 4.36. Forward stabilizer of cross-section stability



Removal
Remove a forward wheel.

Removal of a rack of the stabilizer
Fig. 4.37. Removal of a rack of the stabilizer


Remove stabilizer racks assembled (fig. 4.37).

Arm of fastening of the stabilizer
Fig. 4.38. Arm of fastening of the stabilizer


Remove arms of fastening of the stabilizer and the stabilizer plug (fig. 4.38).
Remove the stabilizer of cross-section stability.
Check
Check the stabilizer of cross-section stability on absence of damages or deformation.
Check all bolts on absence of deformation and damages.
Check protective covers of spherical hinges of racks of the stabilizer on lack of cracks and damages.

Check of the moment of rotation of a finger of the spherical hinge of a rack of the stabilizer
Fig. 4.39. Check of the moment of rotation of a finger of the spherical hinge of a rack of the stabilizer


Check the moment of rotation of a finger of the spherical hinge of a rack of the stabilizer (fig. 4.39).
In the presence of cracks or ruptures of a protective cover of the spherical hinge replace it and add greasing in the hinge.
Several times shake a finger of the spherical hinge of a rack of the stabilizer.
Screw самоконтрящуюся a nut on a finger of the spherical hinge and then measure the moment of rotation of a finger.
Nominal rate: 1,7–3,2 N · m.
If the moment of rotation exceeds the top limit of nominal rate, replace a stabilizer rack.
If the rotation moment is considered less bottom limit of nominal rate, the spherical hinge suitable for further operation while there is no jamming and an excessive gap in the spherical hinge.

Installation
Establish plugs on the stabilizer of cross-section stability.

Distance between edge of the plug and edge the painted white paint of an adjusting label
Fig. 4.40. Distance between edge of the plug and edge the painted white paint of an adjusting label



NOTE
The distance between edge of the plug and edge the painted white paint of an adjusting label on the stabilizer from an external part of the car should make 10 mm (fig. 4.40).


Installation of an arm of fastening of the stabilizer
Fig. 4.41. Installation of an arm of fastening of the stabilizer


Establish an arm of fastening of the stabilizer on the plug (fig. 4.41).
Completely combine the plug with an adjusting label on the stabilizer, the painted white paint. Temporarily tighten bolts of an arm of fastening of the stabilizer, then establish a fastening arm from the opposite side of the stabilizer.

«previous page
4.2.3. Removal, check and installation of the bottom lever of a suspension bracket
following page»
4.3. Back suspension bracket