|
8-2-7-snyatie-i-ustanovka-stekla-dveri-zadka.html
8.2.7. Removal and installation of glass of a door of a back
Removal
|
|
Fig. 8.39. Socket of wires of an element of heating of back glass
|
Disconnect the socket of wires of an element of heating of back glass (fig. 8.39). Remove facing of a door of a back.
Remove the lever and the screen wiper electric motor.
Remove an additional stoplight.
|
NOTE
Procedure is identical to removal of back and wind glasses.
|
Installation
By means of a cutting torch or the adaptation 09861-31200 exactly cut off the glue roller till the thickness about 2 mm from a surface of gluing of glass on all perimeter of a flange of an aperture.
|
ATTENTION
Do not cut off the glue roller till the thickness less specified, and accept precautionary measures not to damage a paint and varnish covering of a body a cutting torch. At damage restore a layer, having put finishing paint.
|
Clear a flange of an aperture of back glass a sponge impregnated with alcohol or means for removal of mastics and degreasing.
Establish new back glass in an aperture and with a soft pencil put labels on glass and a body in four places.
Establish an overlay of back glass, watching that there were no gaps.
Apply a thin film glutinous soil for glasses on an edge of back glass.
Apply a thin film glutinous soil for a body on left on a flange of an aperture of glass a hermetic layer. After drawing of glutinous soil establish glass not later than in 5 minutes.
By means of suckers 09861-31400 impose back glass on an aperture, combining the put labels, and press glass to a hermetic layer.
Remove surplus of glue with a shpatel or erase it a gauze. Fill with glue all emptiness on glass perimeter.
Be convinced of tightness of a windscreen for what water it with a stream of cold water, watching that a strong stream not to damage a fresh glutinous layer. Water so that water flew down on glass edges.
At detection of leakages dry a place of a leakage and put hermetic.
Establish earlier removed details.
|