Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
2.1. Maintenance
2.2. Mechanical part (engine of 1,6 l)
2.3. Mechanical part (engine of 1.8 l)
2.4. Cooling system
2.5. Greasing system
2.6. Power supply system
2.6.1. Removal, check and installation of a final collector
2.6.2. Removal, check and installation of an inlet collector
2.6.3. Removal, check and installation of the air filter
2.7. Control system, fuel system and system of decrease in toxicity
2.8. Tables
3. Transmission
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 









2-6-2-snyatie-proverka-i-ustanovka-vpusknogo-kollektora.html

2.6.2. Removal, check and installation of an inlet collector

Fig. 2.199. Inlet pipeline and throttle branch pipe



Removal
Remove a shumozashchitny casing of the engine.

Fig. 2.200. Inlet air hose


Disconnect an inlet air hose from the butterfly valve case (fig. 2.200).
Disconnect a cable of a pedal of an accelerator.
Disconnect a hose of system of compulsory ventilation of a case and a vacuum hose of the amplifier of brakes.

Fig. 2.201. Servo-driver of a regulator of turns of idling


Disconnect vacuum hoses, the socket of a plait of wires of the servo-driver of a regulator of turns of idling and the socket of a plait of wires of the sensor of provision of a butterfly valve (fig. 2.201).
Before a detachment of a fuel hose of a high pressure from a fuel collector pit residual pressure from топливопроводов a high pressure not to allow a fuel razbryzgivaniye.
Unscrew fastening of an inlet collector.
Remove an inlet collector in collecting and laying.
Disconnect the socket of a plait of wires of fuel nozzles.

Fig. 2.202. Removal of a fuel collector together with nozzles


Remove a fuel collector together with nozzles (fig. 2.202).

ATTENTION
Be careful, do not drop a nozzle at removal of a fuel collector.

Check
Check details on lack of cracks and damages.
Check details on lack of cracks and damages.

Installation
Replace laying of an inlet collector new and establish an inlet collector into place.

ATTENTION
Be careful, do not drop a nozzle at installation of a fuel collector.

Establish a fuel collector together with nozzles.
Connect the socket of a plait of wires of fuel nozzles.
Establish an arm of a support of an inlet collector.
Connect a fuel hose of a high pressure.
Connect a hose of system of compulsory ventilation of a case and a vacuum hose of the amplifier of brakes.
Connect an inlet air hose to the butterfly valve case.
Connect a cable of a pedal of an accelerator.
Connect the socket of a plait of wires of the servo-driver of a regulator of turns of idling and the socket of a plait of wires of the sensor of provision of a butterfly valve.

«previous page
2.6.1. Removal, check and installation of a final collector
following page»
2.6.3. Removal, check and installation of the air filter