Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.4.1. Removal, check and installation of a shaft of a drive of a forward wheel
3.4.2. A shaft of a drive of a forward wheel (the CV JOINT with the jack of length (DOJ) and the CV JOINT «Birfilda BJ»)
3.4.3. Shaft of a drive of a forward wheel (CV JOINT «Tripod TJ»)
3.4.4. Nave of a forward wheel and rotary fist of a detail
3.4.5. Nave of a back wheel
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 







3-4-5-stupica-zadnego-kolesa.html

3.4.5. Nave of a back wheel

Nave of a back wheel
Fig. 3.150. Nave of a back wheel



Removal

ATTENTION
On cars with ABS system remove the sensor of frequency of rotation of a back wheel.
Be careful at removal of the sensor of frequency of rotation of a wheel from an arm not to damage a polar tip of the sensor about teeths of its rotor or other details.

Remove a support of a disk brake and suspend it aside by means of a wire.
Remove a brake disk.
Uncover naves, unscrew a nut of fastening of the bearing of a nave and remove a lock washer.

Nave removal assembled
Fig. 3.151. Nave removal assembled


Remove a nave assembled (fig. 3.151).

ATTENTION
The knot of the bearing of a nave of a back wheel is not subject to dismantle.
Be careful not to scratch or to damage teeths of a rotor of the sensor of frequency of rotation of a wheel. Do not drop a rotor. Formation of chips on teeths of a rotor of the sensor, will lead to deformation of a rotor and, as a result, to impossibility of the correct determination of frequency of rotation of a wheel and violation of work of ABS system as a whole.

Check
Check an epiploon on lack of cracks or damages.
Check the bearing of a nave of a wheel on lack of wear or damages.
Check lack of chips on teeths of a rotor of the sensor of frequency of rotation of a wheel.
Check a fist of a back wheel on lack of cracks.

Installation

Zachekanivaniye of a flange nut
Fig. 3.152. Zachekanivaniye of a flange nut


After an inhaling of a flange nut зачеканьте nut edge on dredging of a shaft of a fist of a back wheel (fig. 3.152).

ATTENTION
Replace a flange nut new after removal.


Sensor of frequency of rotation of a wheel
Fig. 3.153. Sensor of frequency of rotation of a wheel


For cars with ABS system establish the sensor of frequency of rotation of a back wheel. For this purpose insert flat щуп into a gap between a polar tip of the sensor of frequency of rotation of a wheel and tooth of a rotor of the sensor. Fix the sensor so that the gap between a polar tip of the sensor and rotor tooth (on all circle) was in limits of nominal rate (fig. 3.153).
Nominal gap size: 0,2–1,3 mm.
Establish a cover of a nave of a wheel.

«previous page
3.4.4. Nave of a forward wheel and rotary fist of a detail
following page»
3.5. Tables