Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.1.1. General information
3.1.2. Pumping of a hydraulic actuator of coupling
3.1.3. Removal and installation of the main cylinder of a hydraulic actuator of coupling
3.1.4. Removal and installation of a pedal of coupling
3.1.5. Check of the switch of blocking of ignition
3.1.6. Removal, check and installation of a casing of coupling and a conducted disk
3.1.7. Dismantling, check and assembly of the working cylinder of coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 







3-1-4-snyatie-i-ustanovka-pedali-scepleniya.html

3.1.4. Removal and installation of a pedal of coupling

Removal

Removal шплинта
Fig. 3.11. Removal шплинта


Remove шплинт and a washer (fig. 3.11).

Bolts of fastening of a pedal
Fig. 3.12. Bolts of fastening of a pedal


Unscrew bolts of fastening of a pedal (fig. 3.12).

Check of a technical condition
Check an axis and the pedal plug on wear existence.
Check a coupling pedal on bend and distortion existence.
Check a returnable spring on damage or easing existence.
Check a pedal platform on damage or wear existence.

Pedal height over a floor
Fig. 3.13. Pedal height over a floor


Check pedal height over a floor (from an external surface of a platform of a pedal to a floor) (fig. 3.13).
Nominal size "And": 182,7 mm.

Adjustment scheme педели couplings
Fig. 3.14. Adjustment scheme педели couplings


If the pedal height over a floor does not correspond to norm, adjust it, as is shown in drawing 3.14.
Bolt adjust pedal height then tighten a lock-nut.

ATTENTION
After adjustment tighten a bolt so that it concerned a pedal emphasis then tighten a lock-nut.

Rotation of a pusher adjust its length on new height of a pedal then fix a pusher a nut.

ATTENTION
At adjustment of height of a pedal watch that the pusher was not displaced towards the main cylinder.

Upon termination of adjustment be convinced that the free wheeling of a pedal of coupling (measured from a surface of a platform of a pedal) is in norm limits.
Nominal rate "In": 6–13 mm.

Free wheeling of a pedal of coupling
Fig. 3.15. Free wheeling of a pedal of coupling


If the free wheeling of a pedal of coupling does not correspond to norm, the possible reasons are availability of air in a hydraulic actuator or malfunction of the main cylinder. Pump over a hydraulic actuator and check the main cylinder or coupling (fig. 3.15).

«previous page
3.1.3. Removal and installation of the main cylinder of a hydraulic actuator of coupling
following page»
3.1.5. Check of the switch of blocking of ignition