Hyundai Matrix service from 2002 to 2006 of release
1. Operation and car maintenance
2. Engine
3. Transmission
3.1. Coupling
3.1.1. General information
3.1.2. Pumping of a hydraulic actuator of coupling
3.1.3. Removal and installation of the main cylinder of a hydraulic actuator of coupling
3.1.4. Removal and installation of a pedal of coupling
3.1.5. Check of the switch of blocking of ignition
3.1.6. Removal, check and installation of a casing of coupling and a conducted disk
3.1.7. Dismantling, check and assembly of the working cylinder of coupling
3.2. Mechanical transmission
3.3. Automatic transmission
3.4. Driving mechanism
3.5. Tables
4. Running gear
5. Steering mechanism
6. Brake system
7. Onboard electric equipment
8. Body
9. Electric equipment schemes
 







3-1-2-prokachka-gidroprivoda-scepleniya.html

3.1.2. Pumping of a hydraulic actuator of coupling

Pumping of a hydraulic actuator of coupling it is necessary to make each time at removal of the connecting pipeline, a hose and/or the main cylinder of a hydraulic actuator of coupling, and also in a case when the pedal of coupling becomes "soft".

Arrangement of the union of pumping of a hydraulic actuator of coupling
Fig. 3.3. Arrangement of the union of pumping of a hydraulic actuator of coupling


Weaken an union inhaling for pumping on the working cylinder (fig. 3.3).
Slowly press against the stop a coupling pedal until the liquid effluence will stop.
Holding a pedal in extreme forward situation, tighten the union for pumping.
Add in a tank liquid of demanded brand to normal level.

Course of a pedal of coupling when pumping
Fig. 3.4. A course of a pedal of coupling when pumping



ATTENTION
Quickly repeating pressing a pedal in an interval About (fig. 3.4) can lead to that when pumping the piston of the main cylinder will be вытолкнут from the cylinder case. The repeated pressing a pedal should be made only after its complete return to situation A.


Main cylinder of coupling
Fig. 3.5. Main cylinder of coupling




«previous page
3.1.1. General information
following page»
3.1.3. Removal and installation of the main cylinder of a hydraulic actuator of coupling